Jet Ski Graphic Kit

vehiculier

Manufacturers

Graphic Kit for Yamaha FX jet ski (19 and over) Red & Blue

KDYFXBR

RIVOT Racing

Complete decoration kit from RIVOT Racing for Yamaha FX FX HO and SVHO j.. More details

Delivery within 2 to 10 days

399,95€ tax incl.

More info

Complete decoration kit from RIVOT Racing for Yamaha FX FX HO and SVHO jet skis from 2019 and above, mainly Red & Blue in color

Ref. : KDYFXBR



PLEASE SAVE THE PERSONALIZATION FIELDS AT THE BOTTOM OF THE PAGE

The sticker kits are made with ultra-resistant vinyl, as well as reinforced microbead glue and special 100µ thick protection. High Definition Printing.

- Offers optimal protection for your case.
- Under the effect of heat, the vinyl takes shape and adapts to all the contours of your Jet-Ski for greater ease of installation.
- Retains the intensity of its colors for a long time even with strong UV exposure.


ENLARGE THE IMAGE in HD:


Necessary tools :
- A cutter or scissor
- A can of degreaser
- A hair dryer or heat gun (be careful of high temperatures with the gun)
- A raclette
- A soft, clean cloth

Before starting to install your kit, make sure you are in favorable conditions: in a clean and dry place, temperature around 20°C and that you have enough time. Allow 1 to 2 hours to install a kit.


Step 1: Preparing the supports
Clean your fairings several times using a degreaser. It is imperative to remove all traces of glue and grease from plastics even if they are new (silicone residue) because the glue will not adhere properly. Be careful, products such as gasoline, white spirit or “WD40” type products can be effective on certain types of glue, but they are very greasy. Remember to degrease several times if you use it. Do not use window cleaners or acetone.


Step 2: Positioning and gluing
Position the sticker to identify its location. Always start a collage with the rough presentation of the piece to be glued. Little tip: the glue used is in the form of micro beads, this means that you can affix and remove your sticker several times without it sticking permanently. Once you have chosen the appropriate location, all you have to do is scrape the sticker starting from its center which will have the effect of piercing the micro beads and thus triggering the bonding process by polymerization. Once the sticker is in place, remove air bubbles by pressing very hard outwards with a clean cloth and/or a squeegee and/or felt.

Tip: If the piece on which you are working has significant relief, consider lightly heating the sticker with a hairdryer, because under the effect of heat the vinyl will take its shape and apply more easily.


Step 3: Finishes
Finally, once the entire kit is installed, lightly warm each part using a hair dryer and apply significant pressure to the entire kit, paying particular attention to sensitive areas, always using with a soft cloth or squeegee, from the inside out.


Step 4: Imperative!
Leave your decoration kit to rest for 2-3 days, no navigation!!! After the pressure exerted, the glue must have time to polymerize and adapt to its new support.


Tip: If you notice an air bubble, proceed as follows:
Prick the bubble squarely in its center using a pin, keep it pressed, heat
the bubble with the hairdryer then remove the pin while continuing to heat. The hot air
dilated will thus evacuate on its own and the bubble will disappear.

Accessories

Other products in the same category

  • Sticker JOBE - DIECUT STICKER 25X 6.5CM
    Sticker...

    Sticker JOBE - DIECUT STICKER 25X 6.5CM ref....

    2,95€

  • Graphic Kit for Superjet hand jet (-20) Red
    Graphic Kit...

    Complete decoration kit from RIVOT Racing for...

    259,95€

  • Black square Jetpilot stickers 8.5cm
    Black...

    Black square Jetpilot stickers 8.5cm ref. 13605

    1,95€

  • Graphic Kit for Superjet (20+) hand jet Yellow
    Graphic Kit...

    Complete decoration kit from YAMAHA for Yamaha...

    479,95€

  • RACE Ultra 300/310 Turquoise & Pink Graphic Kit
    RACE Ultra...

    Complete RACE decoration kit from RIVOT Racing...

    449,95€

  • RACE Graphic Kit for Seadoo Spark Pink Jet Ski
    RACE...

    Complete RACE decoration kit from RIVOT Racing...

    399,95€

  • SPORT Graphic Kit for Kawasaki 15F jet ski Blue
    SPORT...

    Complete SPORT Decoration Kit from RIVOT Racing...

    399,95€

  • Sticker JOBE - DIECUT STICKER 20X 4.5CM
    Sticker...

    Sticker JOBE - DIECUT STICKER 20 X 4.5CM...

    1,95€

  • RockStar Energy Drink sticker sheet
    RockStar...

    Rock Star Energy Drink sticker sheet ref. SRSED01

    5,97€ -50% 11,95€

  • RACE Graphic Kit for Kawasaki 15F jet ski Pink
    RACE...

    Complete Decoration Kit RACE from RIVOT Racing...

    399,95€

Product customization

After saving your customized product, remember to add it to your cart.

Text

loader

* required fields