SPORT Decoration Kit for Kawasaki 15F Grey & Green

Complete SPORT Decoration Kit from RIVOT Racing for Jet Ski Kawasaki STX 15F in Grey & Green

ref. KDK15FSG&V

PLEASE SAVE THE CUSTOMIZATION FIELDS AT THE BOTTOM OF THE PAGE

The decal kits are made with ultra-resistant vinyl, as well as reinforced microbead glue and a special 100µ thick protection. High Definition printing.

- Provides optimal protection for your hull.
- Under the effect of heat, the vinyl takes shape and adapts to all the contours of your Jet-Ski for greater ease of installation.
- Retains the intensity of its colors for a long time even with strong UV exposure.

ENLARGE IMAGE in HD:

​​​​​

Tools needed:
- A cutter or scissors
- A can of degreaser
- A hair dryer or a heat gun (be careful of high temperatures with the gun)
- A raclette
- A soft, clean cloth

Before you begin installing your kit, make sure you're in the right conditions: a clean, dry place, with a temperature around 20°C, and enough time. Allow 1 to 2 hours to install a kit.

Step 1: Preparation of the supports
Clean your fairings several times using a degreaser. It is imperative to thoroughly remove all traces of glue and grease from the plastics, even if they are new (silicone residue), because the glue will not adhere properly. Be careful: products such as gasoline, white spirit, or "WD40" type products can be effective on certain types of glue, but they are very greasy. Remember to degrease several times if you use them. Do not use window cleaners or acetone.

Step 2: Positioning and gluing
Position the sticker to identify its location. Always start gluing by roughly presenting the piece to be glued. Little tip: the glue used is in the form of micro beads, this means that you can apply and remove your sticker several times without it sticking permanently. Once you have chosen the right location, you will simply need to scrape the sticker starting from its center, which will pierce the micro beads and thus trigger the gluing process by polymerization. Once the sticker is in place, eliminate air bubbles by pressing very firmly outwards with a clean cloth and/or a squeegee and/or felt.

Tip: If the piece you are working on has significant relief, consider heating the sticker slightly with a hair dryer, because the heat will make the vinyl take its shape and apply more easily.

Step 3: Finishing touches
Finally, once the entire kit is in place, lightly warm each piece using a hair dryer and apply significant pressure to the entire kit, paying particular attention to sensitive areas, always using a soft cloth or a squeegee, from the inside out.

Step 4: Imperative!
Let your decoration kit rest for 2-3 days, no navigation!!! After applying pressure, the glue must have time to polymerize and adhere to its new surface.

Tip: If you notice an air bubble, do the following:
Prick the bubble firmly in the center with a pin, keep it pressed, heat
the bubble with the hair dryer then remove the pin while continuing to heat. The hot air
The expanded fluid will then evacuate on its own and the bubble will disappear.