Sport Decal Kit for Ultra 300/310 Grey

Complete SPORT decoration kit from RIVOT Racing for Kawasaki Ultra 300 and 310 Jet Skis in Grey

ref. KDSKU300/310G

PLEASE SAVE THE PERSONALIZATION FIELDS AT THE BOTTOM OF THE PAGE

The decoration kits are made with ultra-resistant vinyl, as well as reinforced micro-bead adhesive and a special 100µ thick protective layer. High Definition printing.

- Offers optimal protection for your case.
- Under the effect of heat, the vinyl takes shape and adapts to all the contours of your Jet Ski for greater ease of installation.
- Retains the intensity of its colours for a long time even with strong UV exposure.

ENLARGE IMAGE in HD:

​​

Tools needed:
- A cutter or scissors
- A can of degreaser
- A hairdryer or a heat gun (be careful of high temperatures with the heat gun)
- A raclette
- A soft, clean cloth

Before you begin installing your kit, make sure you are in favorable conditions: a clean and dry place, a temperature of around 20°C, and that you have enough time. Allow 1 to 2 hours to install a kit.

Step 1: Preparing the supports
Clean your fairings several times with a degreaser. It is essential to thoroughly remove all traces of glue and grease from the plastics, even if they are new (silicone residue), as the glue will not adhere properly. Be aware that products like gasoline, white spirit, or products such as WD-40 can be effective on some types of glue, but they are very greasy. Remember to degrease thoroughly several times if you use them. Do not use glass cleaners or acetone.

Step 2: Positioning and gluing
Position the sticker to determine its placement. Always begin by roughly positioning the piece to be applied. A helpful tip: the adhesive used is in the form of micro-beads, meaning you can reposition your sticker several times without it permanently sticking. Once you have chosen the correct location, simply smooth the sticker, starting from the center. This will pierce the micro-beads and trigger the polymerization process. Once the sticker is in place, remove any air bubbles by pressing firmly outwards with a clean cloth, a squeegee, and/or a felt pad.

Tip: If the piece you are working on has significant reliefs, consider slightly heating the sticker with a hairdryer, because under the effect of heat the vinyl will take its shape and be easier to apply.

Step 3: Finishing Touches
Finally, once the entire kit is in place, gently warm each piece with a hairdryer and apply significant pressure to the entire kit, paying particular attention to sensitive areas, always using a soft cloth or squeegee, working from the inside out.

Step 4: Imperative!
Leave your decoration kit to rest for 2-3 days, no navigation!!! After pressure has been applied, the glue needs time to polymerize and adhere to its new surface.

Tip: If you notice an air bubble, proceed as follows:
Prick the bubble firmly in the center with a pin, keep it inserted, and heat it.
Blow out the bubble with the hairdryer, then remove the pin while continuing to heat. The hot air
The expanded fluid will then escape on its own and the bubble will disappear.